Fakir BOSSY, Manual

BOSSY

GB

17

Nape of the neck (Diagram A): Set the comb position between 4mm and 6mm.Hold the 
clipper with the blade teeth pointing upwards. Begin starting at the centre of the head at 
the base of the neck. Slowly lift the clipper, working upwards and outwards through the 
hair, trimming just a little at a time.
 Back of the head (Diagram B): Set the comb position at 10-12mm or 16-18 mm, cut the 
hair at the back of the head.
Side of the head (Diagram C): Set the comb position between 4mm and 6mm, trim 
sideburns. Then change to the longer setting (10-12mm or 16-18 mm) and continue to 
cut to the top of the head.
 Top of the head (Diagram D): Set the comb position between 22-24mm and 28-30mm 
cut hair on top of the head against the direction in which the hair normally grows. To 
make longer hair on top, use the appliance without comb attachment. Lift the hair on 
top of the head with a small hand comb. Cut over the hand comb with the hair lifted or 
hold the hair between the fingers to lift it and cut it to the desired length. Always work 
from the back of the head.
The finishing touches (Diagrams E, F & G ): Use the clipper without an attachment 
comb for close trimming around the base and sides of the neck. To produce a clean 
straight line at the sideburns, reverse the hair clipper. Place the reversed clipper at right 
angles to the head, tips of the blades lightly touching the skin and then work 
downwards.

Cleaning and maintenance: 

Your clipper is fitted with high quality Titanium and Ceramic blades. To ensure long 
lasting performance of your clipper, clean the blades and unit regularly. After each use, 
• Before cleaning, ensure the clipper is switched off and disconnected from the mains. 
• Brush the accumulated hair from the blades before washing the blades under running 

water. Do not submerge the clipper’s main body in water. 

• To clean the unit, wipe with a damp cloth and dry immediately. 
• Do not use any abrasive substance for cleaning the appliance and its blades. You 

could clean the main body of the appliance with a damp cloth and wash the blades 
under running water. 

• Press the cutters set with the thumb towards the back, remove it from the holder and 

take it off. 

• Ensure that the cutting unit does not fall down. 
• When cleaning the appliance or placing the cutting combs to the appliance, if the 

appliance is plugged in to the mains adaptor, unplug the adaptor from power socket. 

• Always store the appliance in non humid areas. 
• Do store the adaptor cable by curling it around the appliance.