WARNING!
WARNING!
Prior to assembly, make sure that
the main plug is unplugged. If the
main plug is plugged in, the
appliance could accidentally be
switched on, resulting injuries.
ATTENTION!
ATTENTION!
IF the fan blade is blocked, switch
off the cooling fan immediatly and
disconnect it from the power supply.
Eliminate the blockage before
operating the cooling fan again.
ATTENTION!
Do not place the appliance directly
next to any heat sources and avoid
exposure to direct sunlight. Heat
may cause damage to the cooling
fan.
ASSEMBLY
GB
18
ATTENTION!
1-Fit the base feet (23) into the base connector (25) and fix them with
the screws.
2-Mount the fan’s body (26+16) on the telescope pole (19) and fix it
on the pole with the fixing screw.
3-Fit the back grille (6) on the motor (8) to the motor housing (11)
with fastener, and then put the fan blades (4) onto the motor shaft
with fastener. Attach the front grille (2) to rear grille (6), fastening it
with the clamping ring (1) by using a screwdriver and tighten to screw
to secure it.
4-Check the correct rotation of the blades (4).