27
EN
Technical Specifications
2150W
230V
50-60HZ
6,5 Bar Steam Pressure
Before Using
Before using the VIVALDI Steam Station, please ensure you read the user manual
and understand all parts and features of the Steam Station. Be sure to remove any
packaging material and labels before using for the first time.
The Steam Station is designed to be used with normal tap water. In hard water areas,
it is recommended to mix tap water with distilled water in a 1:1 ratio, as minerals and
other elements may cause wear to the Steam Station.
WARNING!
Do NOT fill the Steam Station with the following liquids:
Rain water, bottled water, detergents, descaling agents or any other chemicals.
NOTE!
The Steam Station may give off vapours for up to 10 minutes after first use due to the
initial heating of materials used. This is normal and will subside after the first use.
Filling The Water Tank
1. Push the water tank and release latch up and pull it out. The water tank can be
released and removed.
2. Place the water tank inlet under a tap and fill. Do NOT fill over the MAX level indicator
(1.6L)
3. Slide the water tank back in position and push in, you will hear it click when it is
locked in place.
Operating Instructions
1. Place the Steam Station on a firm level table, bench or ironing board.
2. Plug the unit into a power outlet and switch on at the power point.
3. The Steam Station will start to boil the water.
NOTE!
You will hear the boiler pumping water from the water tank through to the boiler. This
is a normal part of the operation, and will occur whenever Steam Station boils the
water. Do NOT press the steam trigger whilst the Steam Station is heating up.
Summary of Contents for VIVALDI
Page 2: ...Deutsch 3 English 19 Türkçe 35 Русский 51 العربية 69 ...
Page 34: ...NOT NOTES ...
Page 83: ...NOT NOTES ...
