6
INSTALLATION
1.
The cooker hood should be placed at a distance of 65-75cm (26-
30inch) from the cooking surface for the best effect. See Pic 1.
2.
The ceiling must can bear at least 120kgs weight, and the thickness of
the ceiling must be
≧
30MM, see pic 2, drill 1*170mm round hole in
the ceiling.
3.
According to the hanging board, drill 12 holes in the ceiling, see pic 2,
12pcs of ST6*40mm big flat screws will be used to fix the hanging
board on the ceiling, and then 8pcs of M4*10 screws and M4 nut with
gasket will be used to connect the angle iron into the hanging board,
see pic 1, calculated the length of the angle iron, and 16pcs M4*10 big
flat screws and M4 nut with gasket will be used to connect the angle
iron and another angle iron ( the overlap length of angle iron can not
less 100MM)
4.
Let the one side of the extensible pipe go outside through the hole of
170MM, see pic 3.
5.
4pcs ST4*8 big flat screws will be used to connect the internal
chimney into the hanging board, then put one the external chimney,
two hooks will be used to put up the external chimney in order to the
next installation, see pic 4.
6.
Use the screw to fix 4 x corner sheet.see pic 5.
7.
Connect the body with angle iron, then install the valve on the motor
outlet. See pic 6.
8.
Put the extensible pipe on the outlet; after ensure all the things ok, put
down the hook, take from the external chimney, all the installation is
finished, see pic 7,8.
Summary of Contents for FAL-70-ICGW
Page 1: ...Cooker Hood Instruction Manual Model no FAL 70 ICGW...
Page 7: ...7...
