GPS-RECEIVER JP7-T
VERSION 1.02
4 Technical
data
FEATURES
-
OEM single board 12 channel GPS receiver
-
size:
JP7-T : 25,4 x 25,4 x 3 mm (L x B x H)
JP7-TB : 25,4 x 25,4 x 3.3 mm (L x B x H)
JP7-TC-1 : 25,4 x 25,4 x 5.2 mm (L x B x H)
JP7-TC-2 : 25,4 x 25,4 x 5.2 mm (L x B x H)
-
weight:
JP7-T : 2,5 g (without shielding)
JP7-TB : 2,5 g (without shielding)
JP7-TC-1 : 2,5 g (without shielding)
JP7-TC-2 : 2,5 g (without shielding)
-
Casing: Fully
shielded
-
TCXO
-
8Mbit FLASH memory
-
operating voltage:
+3.3 V DC
±
5 %
-
power consumption:
220 mW (continuous mode with Low
Power chipset)
-
temperature range:
-40 to +85 °C (operation, transportation
and storage)
-
protocol: SDI1/
SDO1:
NMEA 9600 baud, Msg.: GLL, GGA,
RMC,
VTG, GSV, GSA
8 data bits, no parity, 1 stop bit
SDI2/ SDO2:
RTCM, 9600 baud
-
trickle power mode:
The default Mode of FALCOM JP7-T is
continuous Mode, but the user can set
FALCOM JP7-T into the Trickle Power
Mode via input command message. The
FALCOM JP7-T family enters the trickle
power mode corresponding to figure 2 (
800
ms OFF Time and 200 ms ON Time
) as soon as
valid GPS data are available. As a result the
average power consumption is reduced by
approximately 80 % (approximately 150
mW). The settings for the trickle power
mode can be modified by using the SiRFstar
demo software. For example if the FALCOM
JP7-T is configured to enter the OnTime
mode each 10 s for a duration of 200 ms the
This confidential document is the property of FALCOM GmbH and may not be copied or circulated without permission.
Page 13
