GPS-RECEIVER JP7-T
VERSION 1.02
To make a properly antenna connection to the antenna pads (available on
bottom side of JP7-TC-2, only) refer to the figure below which shows their
position and pin name (refer also on the table 6).
Figure 13:
RF connection to antenna feed of the JP7-TC-2 GPS receiver.
Recommendations for layout, and soldering.
Please note that, the dimension tolerance is ±0.1 mm.
2.0
0.8
1.9
2.8
1.277
1.5
25.4
25.4
Figure 14:
Recommendations for layout.
This confidential document is the property of FALCOM GmbH and may not be copied or circulated without permission.
Page 43