G
ETTING
S
TARTED
WITH
MAMBO2-B6 EVALKIT
V
ERSION
1.0.3
quick release lever facing rearward. Rotate the quick release lever into position on the lower
part of the clamp (with the lever pointing down) and then flip the Quick Release Lever
upward to lock the clamp into position. If the clamp diameter setting is too loose or too
tight, open the quick release lever, loosen or tighten the lever as necessary to adjust clamp
tightness, and close the lever to check for a secure grip on the bar.
MAKE SURE THE CLAMP IS TIGHT ENOUGH THAT IT WILL NOT MOVE ON THE BAR FROM
VIBRATION OR BUMPS DURING RIDING.
Step 4
Attach the Holding cradle to the handlebar bracket. Slide the assembled cradle onto the
handlebar clamp from back to front until you hear it snaps into the clamp. An audible 'SNAP'
indicates that the cradle is securely attached to the handlebar clamp.
Step 5
Place the MAMBO2 into the cradle by inserting first the two slots located on the bottom of
the MAMBO2 into the two latches on the cradle. Apply light pressure on the MAMBO2
toward the cradle until you hear it snaps into the cradle.
Figure 10:
Quick release clamp.
Step 6
To remove the cradle from the handlebar clamp, just push the latch lock at the front of the
clamp downward, and slide the cradle rearward until it is free from the handlebar clamp.
4.2.2
Car Mounting Kit
If you want to mount your MAMBO2-B6 device in your vehicle on the windscreen, then follow the
instructions given below.
Figure 11:
Car mounting parts.
Step 1
To attach the base plate to the holding frame, unpack these both parts and hold the
base plate against the rear of the holding frame es shown in figure above.
Step 2
Place both parts as is on the back with the cradle on the top and screw the 4 screws by
inserting them through the holding frame into the base plate using the Allen key.
This confidential document is a property of FALCOM and may not be copied or circulated without previous permission.
Page 20 of 24
