C
ONFIGURATION
C
OMMAND
S
ET
- F
IRMWARE
R
EVISION
2.4.0_
BETA
-
V
ERSION
1.0.0
To
re-enable the Bluetooth module only for a time while the device is running
and the Bluetooth module has already been disabled, just send the
command
«$PFAL,Sys.BT.Enable»
to device via SMS or via TCP
connection.
To
re-enable the Bluetooth module to stay always active, the user set
configuration on alarms
AL0
and
AL1
have to be deleted (empty). The
«$PFAL,Cnf.Set,AL0;Cnf.Set,AL1»
command without settings
has to be
sent to device via SMS or TCP connection.
Please note, if you have disabled the Bluetooth functionality and the MAMBOII
device is unable to log in to any network (GSM and/or GPRS, due to: no SIM PIN
has been entered, location area not allowed or roaming not allowed etc.), then the
MAMBOII device is no more accessible either by SMS, TCP nor via Bluetooth
interface. In this case, the first system reset stops power saving and takes the
Bluetooth module for just 20 minutes long back to full functionality (The total time to
establish a Bluetooth connection is estimated to be
20 minutes. However plan
enough time to complete a Bluetooth connection).
3.2.1.12.3 Sys.BT.Reset – Resets the Bluetooth chip
Command syntax
$PFAL,Sys.BT.Reset
Examples
$PFAL,Sys.BT.Reset
Responses
E.g.
$SUCCESS
Command description
This command resets immediately the Bluetooth moule. The event
SYS.BT.eEnable
occurs when the BT restarts.
Parameter description
None.
This confidential document is a property of FALCOM and may not be copied or circulated without previous permission.
Page 62 of 271