C
ONFIGURATION
C
OMMAND
S
ET
- F
IRMWARE
R
EVISION
2.4.0_
BETA
-
V
ERSION
1.0.0
How to set/get PPP configuration:
Set configuration
$PFAL,Cnf.Set,PPP.
AUTOPING=1,300000
Get configuration
$PFAL,Cnf.Get,PPP.
AUTOPING
3.2.22.4 PPP.AUTH
Parameter syntax
This parameter allows you to define the authentification method to be used over
PPP. By default, the authentification over PPP is selected automatically. However, in
some GSM networks it might be required to define the authentification method
manually.
<
auth_type
>
Specifies the authentification method over PPP. It can be set to:
Value
Meaning
none
No authentification is done (
NOT
recommended to use
this setting).
auto
Authentification method is selected automatically.
pap
Only PAP authorization method is used.
chap
Only CHAP authorization method is used.
How the configuration could be set/requested:
Set configuration
$PFAL,Cnf.Set,PPP.
AUTH
=auto
Get configuration
$PFAL,Cnf.Get,PPP.
AUTH
This confidential document is a property of FALCOM and may not be copied or circulated without previous permission.
Page 190 of 271