C
ONFIGURATION
C
OMMAND
S
ET
- F
IRMWARE
R
EVISION
2.4.0_
BETA
-
V
ERSION
1.0.0
3.2.2.6
Cnf.Show - Shows all used parameters
Command syntax
$PFAL,Cnf.Show
Examples
$PFAL,Cnf.Show
Responses
E.g.
$DEVICE.SERIAL.BAUDRATE=115200
$DEVICE.GPS.BAUDRATE=38400
$DEVICE.COMM.SERIAL=cmd,F
$DEVICE.CMD.PFAL.EN=F
$DEVICE.PFAL.SEND.FORMAT="$",CKSUM,"","$<end>"
$DEVICE.BAT.MODE=always,3.55
$DEVICE.IGNTIMEOUT=60000
$DEVICE.SLEEP.IGN=1
$DEVICE.GPS.STARTUP=on
$DEVICE.GPS.AUTOCORRECT=off,5.0,127,50,10
$DEVICE.GPS.TIMEOUT=1,30
$DEVICE.GPS.CFG=3
$DEVICE.GPS.STARTUP=on
$DEVICE.GPS.TIMEOUT=1,30
$DEVICE.GSM.STARTUP=on
$DEVICE.IEEE.STARTUP=off
$DEVICE.IGNTIMEOUT=60000
$DEVICE.SLEEP.IGN=1
$DEVICE.PFAL.SEND.FORMAT="$",CKSUM,"","$<end>"
$DISP.MENU1.0=Phonebook
$DISP.MENU1.1=Office:GSM.VoiceCall.Dial,"+49200000000"
$DISP.MENU1.2=Home:GSM.VoiceCall.Dial,"+493600000000"
$DISP.MENU2.0=Messages
$DISP.MENU2.1.0=Incoming SMS
$DISP.MENU2.1.1=Last SMS:DISPLAY.Show=VIEW_SMS
$DISP.MENU2.2.0=Outgoing SMS
$DISP.MENU2.2.1=Last SMS:DISPLAY.Show=VIEW_SMS
end so on ...
Command description
This command outputs all new defined parameter names.
Parameter description
None.
Notes
•
Default settings are displayed, when no new settings are specified for that
parameter. For example, if the user changes the device name from default
“unnamed MAMBOII” to a new name “myMAMBOII”, and then performs a
request with the “
$PFAL,Cnf.Show
” the MAMBOII outputs the new defined
parameter settings “myMAMBOII” .
•
If the user has cleared a parameter value, the default value will be shown.
This confidential document is a property of FALCOM and may not be copied or circulated without previous permission.
Page 80 of 271