Navi-xs User’s Guide
Version 1.01
6 TROUBLESHOOTING
Q:
The installed software does not seem to establish any connections with NAVI-XS.
How do I make it work?
A: Make sure that your Pocked PC has found the "FALCOM NAVI-XS" Bluetooth™
device. Follow the instructions in the Connection section to make sure that your
Pocked PC has recognized the Bluetooth™ GPS receiver properly. If so, you
need to connect with the device by going to the Bluetooth™ Manager and tab
on the on
Actions
button and then "Connect to GPS_NMEA ..".
Q:
I have established a Bluetooth connection but the NAVI-XS does not seem to have
any GPS fix, what should I do?
A: Shutdown the FALCOM NAVI-XS and turn it on again. Change the location of
NAVI-XS (maybe poor signals are received), but in accordance with the
capability of Bluetooth™ communication
.
Q:
The FALCOM NAVI-XS seems to have a valid GPS fix (GPS indicator is steadily
light), but unable to establish a connection between the NAVI-XS and my Pocked
PC. How can I perform a connection?
A: Go to the Bluetooth™ Manager
→
All devices on your Pocked PC. Tap
Actions
menu and then "
Remove this Device
".
Next, shutdown your FALCOM NAVI-XS, press the
OFF
-button for longer than 2
second. Then perform a soft reset on your Pocked PC. Turn the NAVI-XS on, press
the
ON
-button for longer than 2 second.
Once your Pocked PC has finished resetting itself, go back to the Bluetooth™
Manager screen and perform the typical setup and connection procedures for
your Bluetooth™ receiver (for help with connection, please review the
Connection section).
Finally, run the installed GPS Mapping software, select the assigned COM Port
from Bluetooth™ connectivity, set the baud rate up to 115200 bps (you may or
may not need to modify the COM port setting, it depend on your using
Bluetooth™ device), and click Open Port. The current position will appear on the
GPS Mapping software.
This confidential document is a property of FALCOM GmbH and may not be copied or circulated without previous permission.
Page 28
