16
Do not move the oven by pulling the handrail,
door handles or knobs.
Move the oven a bit at a time, checking behind
it to make sure the gas hose is not caught.
Make sure both electricity and gas cables have
sufficient slack to move the cooker forward as
you go along.
If a stability chain is fitted, release it as you
ease the cooker out.
When you replace the cooker, wind it down off
the rollers by turning the levelling tool anti-
clockwise. This is important. It will stop the
cooker moving accidentally, while in use.
To refit the drawer
To replace the drawer in the cooker, pull the
side rails fully out.
Carefully move the drawer back between the
rails and rest it on the side rails.
At each side hold the front of the drawer and
pull the side rail forward so that the clips click
into position holding the drawer to the side
rails.
Moving your cooker
Switch off the electricity supply.
The cooker is heavy; two people may be
required to move it.
The cooker is fitted with one roller at the front
and two at the back. There are also two screw
down levelling feet at the front.
The front roller, designed for moving the
cooker, can be wound down. The levelling
tool that controls this roller should be in the
storage drawer compartment. If you cannot
find the levelling tool, contact your installer.
See the start of the ‘Installation’ section of these
instructions where they should have entered
their details.
To remove the drawer
Pull the drawer forward.
Lift up the ends of
the plastic clips (one each side) to release the
catches holding the drawer to the side runners
and at the same time pull the drawer forward
and away from the side runners.
For safety push the drawer runners back out of
the way.
Locate the tool as shown.
Turn the levelling tool clockwise, two full (180°)
turns. It will be stiff. The front of the oven will
rise slightly as the roller drops down.
Open the grill door and right hand oven door
so that you can get a good grip on the bottom
of the fascia panel as you move the oven.