23
Unpacking the Cooker
Do not take any packaging off the cooker until it is directly
in front of the place it is to be installed (unless it will not fit
through a door in its outer packaging).
Cut the banding straps and lift the cardboard box off
the cooker, leaving the cooker standing on the base
packaging. See the loose unpacking sheet.
Moving the Cooker
The cooker is very heavy. Take great care.
We recommend two people manoeuvre the cooker.
Ensure that the floor covering is firmly fixed, or removed
to prevent it being disturbed when moving the cooker
around. You will need the levelling tool.
From the back tilt the cooker forward and remove the rear
half of the polystyrene base pack.
Repeat from the front and remove the front half of the
poly base. Pull the drawer out to its furthest point.
Lift up the ends of the plastic clips (one each side) to
release the catches holding the drawer to the side runners
and at the same time pull the drawer forward and away
from the side runners.
For safety’s sake push the drawer runners back out of the
way. Put the drawer some where safe - do not refit it until
the installation is complete
Fit the levelling tool on the rectangular adjuster as shown
below.
LOWER THE FRONT ROLLER by doing 14 complete (360°)
turns clockwise. (This means turning and removing the
levelling tool 56 times).
Now LOWER THE TWO REAR ROLLERS.
First fit the levelling tool on the hexagonal adjusting nut
as shown below.
Make 10 complete (360°) turns clockwise. (This means
turning and removing the levelling tool 20 times).
