User’s Manual
36
NOTE: For the Notify action, the notify item you select should be enabled in the Notification setup screen and
the DVR should be registered in the RAS (Remote Administration System).
Highlight the desired box under the
PTZ
heading, and press the button. A list of PTZ presets appear. Select the
preset position for each PTZ camera, where you want PTZ cameras to move to whenever the DVR detects motion on
the selected camera’s input.
Video Loss
Highlight
Video Loss
in the Event menu and press the button. The
Video Loss
setup screen appears.
Highlight the
Actions
tab,
and the Video Loss
Actions
setup screen appears.
Highlight the box under the
Alarm-Out
heading and press the button. Select between Alarm Output and Beep (DVR’s
internal buzzer) that you would like to activate and to sound whenever the DVR detects video loss on the selected camera.
NOTE: For the Alarm-Out action, the alarm output and beep you select should be set to the Event mode in the
Alarm-Out setup screen (Schedule tab).
Highlight the box under the
Notify
heading and press the button. You can toggle the entire list On and Off by highlighting
Notification
and pressing the button. You can toggle the individual items On and Off by highlighting that item and
pressing the button. Highlight
OK
and press the button to accept your changes.
NOTE: For the Notify action, the notify item you select should be enabled in the Notification setup screen and
the DVR should be registered in the RAS (Remote Administration System).
Highlight the desired box under the
PTZ
heading, and press the button. A list of PTZ presets appear. Select the
preset position for each PTZ camera, where you want PTZ cameras to move to when the DVR detects video loss on
the selected camera’s input.
Figure 48
─
Video Loss Settings setup screen.
Highlighting the box under the
Video Loss Interval
heading
allows you to set the duration of a signal loss before the DVR
will report a Video Loss. The DVR will not consider any signal
loss from a camera to be a Video Loss if the detected signal
loss is shorter than the interval set on this screen.
Figure 49
─
Video Loss Actions setup screen.
The DVR can be set to react to video loss differently for each
camera. Each camera can be associated with another camera,
trigger an Alarm-Out connector, sound the DVR’s internal
buzzer, notify a number of different devices, and/or move PTZ
cameras to preset positions.
Highlight the box under the
Record
heading and press the
button. A list of cameras appears. You can associate as many
cameras with that camera as you wish. If the DVR detects
video loss on the selected camera, it starts recording video
from all the associated cameras.
NOTE: For the Record action, the camera you select
should be set to the Event or Time & Event recording mode
in the Record Schedule setup screen.
Summary of Contents for 4-Channel
