![background image](http://html1.mh-extra.com/html/falcon/90/90_instructions-for-use-and-installation_3261118031.webp)
English
31
Place the cooker in its intended position taking care not to
twist it within the gap between the kitchen units as dam-
age may occur to the cooker or the units.
The front feet and rear rollers can be adjusted to level the
cooker. To adjust the height of the rear of the cooker use
the levelling tool supplied to turn the adjusting nuts at the
front bottom corners of the cooker.
To set the front feet turn the bases to raise or lower.
Fit the Handles (some models only)
Remove the 4mm Allen screws from the doors with the
hexagon key tool. Use the screws to fit the door handles.
The handles should be above the fixings.
Remove the 4mm Allen screws from the top corners of the
facia and fix the front handrail in position.
Fitting the splash back (optional - some
models only)
view from the rear of the cooker
Remove the two fixing screws (3mm hexagonal socket
head) and nuts that pass through the top of the rear flue
grille. Hold the splash back in position. From the rear refit
the 2 fixing screws and nuts.
Electrical Connection
This appliance must be installed by a qualified electrician
to comply with the relevant regulations and also the local
electricity supply company requirements.
WARNING: THIS APPLIANCE MUST BE EARTHED
Note
The cooker must be connected to the correct electrical
supply as stated on the voltage label on the cooker,
through a suitable cooker control unit incorporating a dou-
ble pole switch having a contact separation of at least
3mm in all poles. This cooker must not be connected to an
ordinary domestic power point.
The total electrical load of the appliance is approximately
15.6kW. The cable size used should be suitable for this
load and comply with all local requirements.
Access to the mains terminal is gained by removing the
electrical terminal cover box on the back panel.
Connect the mains cable to the correct terminals for your
electrical supply type. Please note the maximum cable
sizes are 6mm
2
for the screw terminals and 10mm
2
for the
3 pronged links.
Check that the links are correctly fitted and that the termi-
nal screws are tight. Secure the mains cable using the ca-
ble clamp.
Fitting the plinth
Summary of Contents for 90
