Falcon 900S Dual Fuel, User Giude

18

ArtNo.090-0009 - 90 2BC cooker min spacings

220°

180°

140

°

100°

����

���

����

���

�����

���

���������
���������

Fig.7-1

�������������������������������������������

ArtNo.281-0017 - Removing the door

Fig.7-4

Fig.7-3

Positioning the Cooker

The diagrams show the minimum recommended distance 
from the cooker to nearby surfaces 

(Fig.7-1)

.

The cooker should not be placed on a base.

The hotplate surround should be level with, or above, 
any adjacent work surface. A gap of 75mm should be left 
between each side of the cooker 

ABOVE

 the hotplate level 

and any adjacent vertical surface.

For non-combustible surfaces (such as unpainted metal or 
ceramic tiles) this can be reduced to 25mm.

A minimum space of 650mm is required between the top of 
the hotplate and a horizontal combustible surface. 

Fig.7-2 

shows the suggested clearances above the cooker.

*Any cooker hood should be installed in accordance with the 
hood manufacturer’s instructions.

Surfaces of furniture and walls at the sides and rear of the 
appliance should be heat, splash and steam resistant. Certain 
types of vinyl or laminate kitchen furniture are particularly 
prone to heat damage and discolouration. We cannot accept 
responsibility for damage caused by normal use of the 
cooker to any material that de-laminates or discolours at 
temperatures less than 65°C above room temperature.

We recommend a gap of 905mm between units to allow for 
moving the cooker. If a flush fit is required, fit the cooker up 
to the unit at one side then fit the unit the other side. Do not 
box the cooker in – it must be possible to move the cooker in 
and out for cleaning and servicing.

If the cooker is not installed between units, a side panel 
extension that closes the gap to the wall at the rear is 
available as an optional extra kit.

Unpacking the Cooker

Do not take any packaging off the cooker until it is directly 
in front of the place it is to be installed (unless it will not fit 
through a door in its outer packaging).

Cut the banding straps and lift the cardboard box off the 
cooker, leaving the cooker standing on the base packaging. 
See the loose unpacking sheet.

Moving the Cooker

 

On no account try and move the cooker while it is 
plugged into the electricity supply.

 

The cooker is very heavy, so take great care.

We recommend two people manoeuvre the cooker. Ensure 
that the floor covering is firmly fixed, or removed to prevent it 
being disturbed when moving the cooker around. To help you, 
there are two levelling rollers at the back and two screw-down 
levelling feet at the front. You will need the levelling tool.

Removing the Oven Door

To remove the door, open the door fully. Swivel the locking ‘U’ 
clips forward to the locking position 

(Fig.7-3)

. Grip the sides 

of the door, lift upwards and then slide the door forwards 

(Fig.7-4)

 and remove.

ArtNo.092-0006 - 900S DF min positions above cooker

220°

18

0°

140

°

100°

���������

����������

�����

�����

Fig.7-2

English