INSTALLATION
Check the appliance is electrically safe and gas sound when you have finished.
21
Electrical Connection
This appliance must be installed by a qualified electrician
to comply with the relevant Institute of Electrical Engineers
(I.E.E.) regulations, and also the local electricity supply
company requirements.
WARNING: THIS APPLIANCE MUST BE EARTHED
Note:
The cooker must be connected to the correct
electrical supply as stated on the voltage label on
the cooker, through a suitable cooker control unit
incorporating a double pole switch having a contact
separation of at least 3mm in all poles. This cooker must not
be connected to an ordinary domestic power point.
The total electrical load of the appliance is approximately
3.6kW. The cable size used should be suitable for this load and
comply with all local requirements.
Access to the mains terminal is gained by removing the
electrical terminal cover box on the back panel. Connect
the mains cable to the correct terminals for your electrical
supply type
(Fig.7-12
and
Fig.7-13)
. Check that the links are
correctly fitted and that the terminal screws are tight. Secure
the mains cable using the cable clamp.
These appliances are of type X with regard to protection
against over heating of the surrounding surfaces.
Hotplate Check
Check each burner in turn. There is a flame safety device (FSD)
that stops the flow of gas to the burner if the flame goes out.
For each burner, turn the control knob to the solid flame
symbol. Press in the control knob. This lets gas through to
the burner. Keep holding the knob pressed in and press the
igniter button or light with a match. Keep holding the control
knob pressed in for about 10 seconds.
If when you let go of the control knob the burner goes out,
the safety device has not held in. Wait one minute then try
again this time holding the control pressed in for slightly
longer.
Oven Check
Turn on the oven and check that it starts to heat up. Check
that the oven lights are working.
Note:
The oven light bulb is not included in the guarantee.
Turn off the oven.
ArtNo281-0025 Albertine 1 Phase DF
Fig.7-12
ArtNo.000-0011 Electrical connections 3-phase
N
L1 L2 L3
N
L1
L3
L2
3N ac
230/400V 50Hz
Fig.7-13
