15
Australia
To fi t the small inner burner, fi nd the larger
electrode notch in the burner rim. Line this up with
the white ignition electrode and place the inner
burner on the large base ring.
A electrode notch
B
ignition electrode
Now fi t the two trim rings, making sure that they
are sitting down properly.
Griddle
Always clean the griddle after use. Allow to cool
completely before removing. Immerse the griddle
plate in hot soapy water. Use a soft cloth or, for
stubborn stains, a nylon washing up brush.
NEVER USE CAUSTIC OR ABRASIVE CLEANERS AS
THESE WILL DAMAGE THE SURFACE.
Control Panel and Doors
Avoid using any abrasive cleaners including cream
cleaners, e.g. Jif, on brushed Stainless Steel surfaces.
For best results use a liquid detergent.
The control panel and control knobs should only
be cleaned with a soft cloth wrung out in clean
hot soapy water -
but take care that no surplus
water seeps into the appliance.
Wipe with a clean
dampened cloth then polish with a dry cloth. The
oven doors should only be cleaned with a soft cloth
wrung out in clean hot soapy water.
Stainless Steel Cookers with window doors
If the inside face of the glass on window door
model becomes marked, the oven door front panel
can be taken off so that the glass panels can be
cleaned.
Move the cooker forward to gain access to the
sides (see the ‘Moving the cooker’ section of these
instructions).
Open the oven door slightly and remove the front
panel fi xing screws from the door sides (two each
side).
stainless steel window doors only
Carefully lift off the outer door panel. The inside
face of the glass panels can now be cleaned - take
care not to disturb or wet the door insulation.
Please note that the door is triple glazed but the
inner two panels are fi xed and should not be
separated. After cleaning carefully refi t the outer
door panel and replace the side fi xing screws.
The Ovens
The ovens have removable panels that have been
coated with a special enamel that partly cleans
itself. This does not stop all marks on the lining, but
helps to reduce the amount of manual cleaning
needed.
The Cook & Clean panels work better above
200°C. If you do most of your cooking below
this temperature, occasionally remove the
panels and wipe with a lint free cloth and hot
soapy water. The panels should then be dried
and replaced and the oven heated at 200°C
for about one hour. This will ensure the Cook
& Clean panels are working eff ectively.
Don’t use steel wool (Brillo) or any other materials
that will scratch the surface. Don’t use oven
cleaning pads.
Removing the Oven Linings
Some of the lining panels can be removed for
cleaning and for cleaning behind. Remove the
shelves fi rst.
On some models the
right hand fanned
oven has a removable
oven roof - if fi tted
slide the roof liner
forward and remove.
