34
WARNING SERVICING TO BE CARRIED OUT ONLY BY AN AUTHORISED PERSON
Disconnect from electricity before servicing. Check appliance is safe when you have finished.
20. To Remove RH Oven Inner Back.
Open RH oven door and remove the screws and washers
securing the inner back to the back of the oven.
Carefully lift away the inner back. Reassemble in reverse
order making sure that the 4 screws and washers are fully
tightened.
21. To Change Fan in RH Oven.
Disconnect from electricity supply.
Pull cooker forward to gain access to the rear. Remove
screws securing the electric cover to the back sheet and
remove cover. Disconnect the 3 terminals connected to the
fan noting their position. Remove oven inner back (see 20).
Hold the fan blade and remove the centre nut (left hand
thread) 2 brass washers, fan blade and Circlip. Unscrew fan
retaining nuts and washers (3 off each) and lift the fan away
from the rear of the cooker. Fit new fan and reassemble in
reverse order. Check operation of oven.
22. To Remove RH Oven Element.
Disconnect from electricity supply.
Remove oven inner back (see 19).
Remove 2 screws from the top of the element and 1 from
the bottom of the element in side the oven. Lift element
out carefully, disconnect the terminals connected to
the element noting their positions. If it is not possible to
disconnect the leads in this way, pull cooker forward to gain
access to the rear, remove screws securing the electric cover
to the back sheet and remove cover and disconnect the
terminals from the rear.
Fit new element, and reassemble in reverse order. Check
operation of oven.
23. To Remove LH Oven Elements.
Disconnect from electricity supply.
Pull cooker forward to gain access to the rear. Remove
screws securing the electric cover to the back sheet and
remove cover. Remove the 4 terminals connected to the
top element noting their position. Remove 2 screws and
washers securing the bottom element cover. Remove
the 2 terminals connected to the bottom element noting
their position. Remove 2 screws and washer from the
bottom element support. Remove 2 screws and washer
from the element bracket and withdraw the element. Fit
new element, reassemble in reverse order. Open LH oven
door and remove 2 screws and washers securing the top
element heat shield. Remove 2 screws and washers from
the top element bracket and withdraw. Fit new element,
reassemble in reverse order. Check operation of oven.
24. To Change Oven Light Bulb.
Disconnect from electricity supply.
Make sure the oven is cool. Open the oven door and remove
the oven shelves.
Unscrew the bulb cover by turning anticlockwise. It may be
very stiff .
Taking care to protect your fi ngers in case the bulb should
shatter, unscrew the old bulb.
Fit an Edison screw fi tting 15w 240v lamp, FOR OVENS. It
must be a special bulb, heat resistant to 300°C.
Screw in the new bulb, screw back the bulb cover. Turn on
the electricity supply and check that the bulb now lights.
