34
WARNING SERVICING TO BE CARRIED OUT ONLY BY AN AUTHORISED PERSON
Disconnect from electricity before servicing. Check appliance is safe when you have finished.
23. To Change Oven Door Outer Panel
Move the cooker forward to gain access to the sides.
Classic and Falcon 110 models
Toledo & Profesional models
Open the oven door slightly and remove the front panel
fi xing screws from both sides of the outer panel (A).
Carefully lift off the outer panel.
Remove the door handle from the panel by unscrewing the
2 retaining nuts.
Fit the door handle to the new panel. Fit the new panel to
the door. Then reassemble in reverse order.
24. To Change Oven Door Latch
Remove outer door panel (see 22). Remove screws ‘B’
holding latch assembly to inner door panel. Fit new catch
and reassemble in reverse order.
Check correct door operation.
25. To Change Warmer Neon
Disconnect from electricity supply.
Remove RH hotplate (see 2). Carefully place hotplate upside
down on a suitable fl at surface. Remove 2 screws holding
neon bracket to Warmer frame. Fit new neon and bracket
assembly.
Reassemble in reverse order and check for correct
operation.
26. To Change Warmer
Disconnect from electricity supply.
Remove RH hotplate, see 2. Fit new RH hotplate and
reassemble in reverse order.
Check High burner and Warmer operation is
satisfactory.
27. To Adjust an Oven Door Catch Keep
Open oven door, slacken off locknut at base of keep, and
screw in or out as required until required fi t is obtained.
Retighten locking nut.
28. To Change Oven Door Seal
Open oven door. The seal is held in place by small hooks on
the rear face. At the corner pull seal diagonally away from
the door centre until that hook is released. Proceed to the
next hook and release it in a similar way, and so on.
Use force if the hooks are stiff , as the old seal will be
discarded.
When fi tting new seal, position the seal join at the bottom.
Hook the new seal in one of the corner holes of the door,
and proceed round the door snapping in each hook in turn.
29. To Change Oven Light Bulb.
Disconnect from electricity supply.
Make sure the oven is cool. Open the oven door and remove
the oven shelves.
Unscrew the bulb cover by
turning anticlockwise. It
may be very stiff .
