Falcon Classic 90 Gas, User'S Manual & Installation Instructions

15

ArtNo.330-0003 - Grill pan w handle pulled forwards

Fig.5-5

The Griddle

Always clean the griddle after use. Allow it to cool completely 

before removing. Immerse the griddle plate in hot soapy 

water. Use a soft cloth or, for stubborn stains, a nylon washing 

up brush.

Note: 

If the griddle is washed in a dishwasher then some 

dishwasher residue may appear on the back. This is normal 

and will not affect the performance of your griddle.

Grill

n

n

Before you remove any of the grill parts for cleaning. 

make sure that they are cool, or use oven gloves.

The face of the grill burner will darken with use – this is 

perfectly normal. Any fat or grease will burn off. Do not try to 

clean it – the small holes could get blocked and affect burner 

performance.
The grill pan can be easily removed for cleaning 

(Fig.5-5)

.

The grill pan and trivet should be washed in hot soapy water, 

alternatively, the grill pan can be washed in a dishwasher.
After grilling meats or any foods that soil, leave to soak for 

a few minutes in the sink immediately after use. Stubborn 

particles may be removed from the trivet by using a nylon 

brush.

Control Panel and Doors

Avoid using any abrasive cleaners including cream cleaners. 

For best results, use a liquid detergent.
The same cleaner can be used on the doors or, alternatively 

using a soft cloth wrung out in clean hot soapy water – but 

take care that no surplus water seeps into the appliance.
After cleaning, polish with a dry cloth.

Glass Fronted Door Panels 

(some models)

The oven door front panels can be taken off so that the glass 

panels can be cleaned. Move the cooker forward to gain 

access to the sides (see the 

‘Moving the Cooker’

 section under 

‘Installation’

).

Open the oven door slightly and remove the front panel 

fixing screws from the door sides, two each side 

(Fig.5-6)

.

Carefully lift off the outer door panel. The inside face of the 

glass panels can now be cleaned – take care not to disturb or 

wet the door insulation.

Note:

 If the door is triple glazed then the inner two panels are 

fixed together and should not be separated. After cleaning, 

carefully refit the outer door panel and replace the side fixing 

screws.

Fig.5-6