TYRE CARE AND WHEEL ADJUSTMENTS CONTINUED
QUICK RELEASE FRONT WHEEL
1.
To remove the front wheel, first release the front wheel brake. Then open the
quick-release lever on the axle and pull the wheel from the forks.
2.
To install, fit wheel into forks with quick release lever on the left side. Close quick-
release, and tighten adjuster until snug. Release quick-release lever and further
tighten adjuster approximately 3/4 of a turn. Lock and check that the quick-release has
embossed the fork ends. It may be necessary to tighten or loosen the adjuster slightly.
Make certain to reset the quick-release front brake to ensure proper operation.
3.
Wheel must be clear frame and fork by at least 1/16".
4.
The wheel should turn freely and have very little side-play.
5.
Check quick-release lever is correct and fully locked position before each ride.
FITMENT OF BELL
1.
Remove screw from bell clamp.
2.
Position in a convenient spot near the left hand or right hand handlebar grip.
3.
Replace screw & tighten securely.
4.
Rotate the “Ping Arm” to a comfortable position.
5.
Check quick-release lever is correct and fully locked position before each ride.
Spring
Spring
Adjusting nut
Quick Release Lever
Closed
Open
Locked position
Retaining Device
WARNING! Do not attempt to ride the cycle until you are
absolutely sure that the quick release lever is fully closed and
securely tightened. Children should check with their parents to
ensure that this has been tightened correctly.
Ping Arm
Brake Lever/Shifter
Grip
Position Bell on left hand or right hand side of the handlebar as required.
19
