Code
Error
Cause
Action by user
01
Hardware
over coil
Unsuitable pan material
Wrong or defective coil
Use suitable pan
Call Service Engineer.
02
No inductor
current
Inductor connection failure
Call Service Engineer.
03
Heat sink
temperature
too high
Air routes blocked. Fan filter
clogged. Generator
temperature sensor defective
Clear air routes. Clean fan air
intake filter. If still faulty,
call Service Engineer.
04
Cooking zone
temperature too
high or too low
Pan empty
Pan base distorted
Coil temperature sensor faulty
Remove pan, check pan base. Switch
off, allow zone to cool and try again.
If still faulty, call Service Engineer.
05
Control
unit failure
Control / switch assembly is
faulty or wired incorrectly
Call Service Engineer.
06
Internal
temperature
too high
Air routes blocked. Fan filter
clogged. Temperature sensor
faulty, external heat
sources too close
Clear air routes. Clean fan filter.
Remove any external heat source.
If still faulty, call Service Engineer.
07
Cooking zone
temperature
sensor
Short circuit at
temperature sensor
Call Service Engineer.
08
Mains phase
failure
Fault in mains supply
Call Service Engineer.
10
Communication
error
Failure in LIN or CAN-Bus
No connection between
keyboard and generator
Disconnect from mains.
Reconnect and test again.
Call Service Engineer.
11
Initialisation
error
Failure while
initialising hardware
Wait. Generator will reset every
30 seconds. Try switching off and on.
Call Service Engineer.
12
Mains current
failure
Failure while generator
measures mains current
Call Service Engineer.
13
Mains
connection
error
Mains voltage too high or
too low
Call Service Engineer.
14
Mains adaptor
error
Mains voltage too high or
too low
Call Service Engineer.
15
Protective
electrical circuit
Pan empty,
faulty sensor
Remove pan, switch off and allow
cooking zone to cool.
Call Service Engineer.
ERROR CODE TABLE
7
Summary of Contents for E3913i
Page 9: ...9...
