15
3.1.12 If the unit is fitted with PTFE liners, ensure any debris that has collected behind the
liners is removed on a daily basis.
3.1.13 The PTFE sheeting should be cleaned using non-corrosive agents. Warm water and
detergent is recommended.
3.2 PTFE FITTING
3.2.1 Remove Splashguards, front and rear PTFE Clamps and old PTFE Liner.
3.2.2 Lift the elements to the vertical position and engage locking pin.
3.2.3 Fit front & rear liners into appliance and fold PTFE to match the profile of the hob and
pan. Flatten any wrinkles or creases out of the liner against the hob and pan surfaces
as required.
THE PTFE SHEET SHOULD NOT BE ALLOWED TO COME
INTO CONTACT WITH THE ELEMENTS WHEN HOT.
DO NOT USE SHARP OR ABRASIVE MATERIALS TO CLEAN
THE PTFE SHEETING.
DISHWASHING THE PTFE SHEETING IS NOT
RECOMMENDED.
Summary of Contents for E9460
