CHAPTER
CHAPTER
2
2
Installation
Inspecting the Equipment
If any FALCON
®
equipment has been damaged during shipment, keep
the shipping cartons and packing materials for the carrier and file a
claim for shipping damage. If you discover damage after acceptance,
file a claim for concealed damage.
To file a claim for shipping damage or concealed damage: 1) File with
the carrier within 15 days of receipt of the equipment; 2) Send a copy
of the damage claim within 15 days to the Falcon
®
Service Department.
UPS Setup
1.
Verify that the following is included in the UPS shipping carton:
UPS, Owner's Guide..
2.
Verify that the UPS unit is configured for the proper input/output
voltage. This information is stated on the nameplate label located on
the rear panel of the unit.
3.
Select a suitable location for the UPS, near enough to the computer or
equipment to allow connection of the equipment power plug to the
receptacles located on the rear panel of the UPS.
4.
When installing this UPS into a rack enclosure the following must be
followed:
a. Due to the UPS weight it must be installed using a rack
mounted shelf or using slides manufactured by General
Devices, part number CLB-203-20, using (8) Phillips, pan
head 8-32 x 3/8” screws, (4) per slide.
b. Secure the UPS front panel to the rack rails using four screws
supplied by the rack manufacturer.
5.
DO NOT BLOCK UPS AIR VENTS. THE UPS MUST NOT BE
INSTALLED IN AN ENCLOSED AREA.
6.
If you have not already done so, connect the equipment to be
protected to the UPS output receptacles located on the rear panel.
Verify that the connected equipment does not exceed the rated output
(in watts) of the UPS.
IMPORTANT
7.
Plug the UPS power cord into the nearest grounded wall outlet. If the
UPS does not power up automatically, depress and hold the control
button located on the UPS front panel until the UPS turns on.
5
