Falcon Elise SE 110 Dual Fuel, User'S Manual & Installation Instructions

13

ArtNo.311-0032 Burner layout FSD

A

B

C

D

E

ArtNo.311-0033 Wok burner details FSD

A

B

C

D

E

ArtNo.311-0016 Fitting the burner inner head 

A 

B 

Fig.5-1

Fig.5-2

Fig.5-3

Fig.5-4

A – Cap,   B – Head,   C – Notch,   D – Base,   E – Electrode

A – Inner burner cap,   B – Outer burner cap,   C – Inner burner head,   

D – Outer burner head,   E – Wok burner base

A – Electrode notch,   B – Ignition electrode

5.  Cleaning Your Cooker

Essential Information

Isolate the electricity supply before carrying out any 

thorough cleaning. Allow the cooker to cool.

n

n

NEVER use paint solvents, washing soda, caustic 

cleaners, biological powders, bleach, chlorine based 

bleach cleaners, coarse abrasives or salt. 

n

n

DO NOT mix different cleaning products – they may 

react together with hazardous results.

All parts of the cooker can be cleaned with hot soapy water 

– 

but take care that no surplus water seeps into the 

appliance.

Remember to switch on the electricity supply and reset the 

clock before re-using the cooker.

Hotplate Burners

The burner heads and caps can be removed for cleaning. 

n

n

DO NOT put the burner heads in a dishwasher.

Make sure they are absolutely dry before replacing them.

The Single Ring Burners

When refitting the burner head, make sure that the notch 

lines up with the electrode or hole in the base. Check that the 

burner head is level and that the cap is fitted centrally on the 

burner head 

(Fig.5-1)

.

The Wok Burner

The wok burner can also be taken apart for cleaning.
When reassembling the wok burner 

(Fig.5-2)

, turn over the 

large base ring and find the ‘D’ shaped area 

(Fig.5-3)

. Turn the 

head until the ‘D’ matches the one on the burner base. Flip 

the burner over once again and place it on the burner base.
To fit the small inner burner, find the larger electrode notch in 

the burner rim. Line this up with the white ignition electrode 

and place the inner burner on the large base ring 

(Fig.5-4)

.

Now fit the two burner caps, making sure that they are seated  

properly.
Check the burner ports are not blocked. If a blockage occurs, 

remove stubborn particles using a piece of fuse wire.

The Wok Cradle

Recommended cleaning materials are hot soapy water, a 

moistened soap pad, cream cleaner or a nylon scourer.