Falcon Elise SE 110 Dual Fuel, User'S Manual & Installation Instructions

INSTALLATION

Check the appliance is electrically safe and gas sound when you have finished.

21

ArtNo.070-0014 - Stability bracket - Wall fitting

Cooker

Stability bracket

Floor

3 mm min

Typical floor mounting

ArtNo.010-0004 Moving the cooker

Fig.7-5

Fig.7-6

Moving the Cooker

n

n

On no account try and move the cooker while it is 

plugged into the electricity supply.

n

n

The cooker is very heavy, so take great care.

We recommend that two people manoeuvre the cooker. 

Make sure that the floor covering is firmly fixed, or removed, 

to prevent it being disturbed when moving the cooker 

around.
To help you, there are two levelling rollers at the back, and 

two screw-down levelling feet at the front.
Remove the polystyrene base pack. From the front, tilt 

the cooker backwards and remove the front half of the 

polystyrene base 

(Fig.7-4)

. Repeat from the back and remove 

the rear half of the polystyrene base.

Lowering the Two Rear Rollers

To adjust the height of the rear of the cooker, first fit a 13 mm 

spanner or socket wrench onto the hexagonal adjusting 

nut 

(Fig.7-5)

. Rotate the nut – clockwise to raise – counter-

clockwise to lower.
Make 10 complete (360°) turns clockwise.
Make sure you lower BOTH REAR ROLLERS. 

Completing the Move

Unfold the rear edge of the cardboard base tray. Open the 

oven doors so that you can get a good grip on the bottom of 

the fascia panel as you move the oven 

(Fig.7-6)

.

Carefully push the cooker backwards off the base tray. 

Remove the base tray.
Position the cooker close to its final position, leaving just 

enough space to get behind it.

n

n

DO NOT use the door handles or control knobs to 

manoeuvre the cooker.

Fitting the Stability Bracket or Chain

Unless otherwise stated, a cooker using a flexible gas 

connector must be secured with a suitable stability device.
Suitable stability devices are shown in 

Fig.7-7

, 

Fig.7-8

 and 

Fig.7-9

.

If you are using a stability chain 

(Fig.7-7)

 then the chain 

should be kept as short as is practicable and fixed firmly to 

the rear of the cooker.
If you are using a stability bracket (

Fig.7-8

 and 

Fig.7-9

), then 

adjust the bracket to give the smallest practicable clearance 

between the bracket and the engagement slot in the rear of 

the cooker.
Fit the bracket so that it engages as far as possible over the 

chassis of the cooker.

Fig.7-7

Fig.7-8

Stability chain

Cooker

Outer stability

bracket

Floor

Wall

3 mm min

Typical wall mounting

Fig.7-9