Falcon Elise SE 110 Dual Fuel, User'S Manual & Installation Instructions

INSTALLATION

Check the appliance is electrically safe and gas sound when you have finished.

24

ArtNo.281-0026 - Front plinth

Fig.7-15

Electrical Connection

The cooker must be installed by a qualified electrician, in 

accordance with the relevant national and local regulations.

Note: 

The cooker must be connected to the correct electrical 

supply as stated on the voltage label on the cooker, through 

a suitable cooker control unit incorporating a double-pole 

switch, having a contact separation of at least 3 mm in all 

poles.

n

n

The cooker MUST NOT be connected to an ordinary 

domestic power point.

Access to the mains terminal is gained by removing the 

electrical terminal cover box on the back panel. Connect the 

mains cable to the correct terminals for your electrical supply 

type 

(Fig.7-13)

. Check that the links are correctly fitted and 

that the terminal screws are tight. Secure the mains cable 

using the cable clamp.

Final Checks

Hotplate Check

Check each burner in turn (refer to the 

‘Hotplate Burners’

section at the front of the instructions).

Grill Check

Turn on the grill control and check that the grill heats up.

Oven Check

Turn on the ovens. Check that the oven fans start to turn and 

that the ovens start to heat up.

Note:

 The oven light bulb is not included in the guarantee.

Turn off the ovens.

Final Fitting

Fitting the Pan Supports

Please note that the outer pan supports are handed, and may 

prevent the centre pan supports from fitting correctly. There 

is a small indent in the rear of each of the outer supports. 

This indent should be towards the outer edge of the cooker 

(Fig.7-14)

.

Fitting the Plinth

Loosen the 3 screws along the front bottom edge of the 

cooker. Hook the central keyhole over the central screw. Twist 

and fit each end keyhole over their respective screws. Tighten 

the fixing screws 

(Fig.7-15)

.

Customer Care

Installer:

 Please complete your details in this guide, inform 

the user how to operate the cooker and hand over the 

instructions.

Thank you.

ArtNo.130-0010 Electrical connections single-phase 

L 

N 

230 V ac 50 Hz

10 mm² max

6 mm² max

Fig.7-13

Current Operated Earth Leakage Breakers

The combined use of your cooker and other domestic 

appliances may cause nuisance tripping, so we 

recommend that the cooker is protected on an individual 

RCD (Residual Current Device) or RCBO (Residual Current 

Breaker with Overload).

IF IN DOUBT, PLEASE CONSULT A SUITABLY QUALIFIED 

ELECTRICIAN.

Fig.7-14