Falcon Hi-LITE 110, User'S Manual & Installation Instructions

17

Control Panel and Doors

Avoid using any abrasive cleaners, including cream cleaners. 

For best results, use a liquid detergent.
The same cleaner can be used on the doors, or alternatively, 

using a soft cloth wrung out in clean hot soapy water – but 

take care that no surplus water seeps into the appliance.
After cleaning, polish with a dry cloth.

Glass Fronted Door Panels

The oven door front panels can be taken off so that the glass 

panels can be cleaned. Move the cooker forward to gain 

access to the sides (see the 

‘Moving the Cooker’

 section under 

‘Installation’

).

Open the oven door slightly and remove the front panel 

fixing screws from the door sides, two each side 

(Fig.5-11)

.

Carefully lift off the outer door panel. The inside face of the 

glass panels can now be cleaned – take care not to disturb or 

wet the door insulation.

Note: 

If the door is triple glazed then the inner two panels are 

fixed together and should not be separated. After cleaning, 

carefully refit the outer door panel and replace the side fixing 

screws.

n

n

DO NOT use harsh abrasive cleaners or sharp metal 

scrapers to clean the oven door glass since they can 

scratch the surface, which may result in shattering of 

the glass.

Ovens

'Cook & Clean' Panels

The ovens have side ‘Cook & Clean’ panels which have been 

coated with a special enamel that partly cleans itself. This 

does not stop all marks on the lining, but helps to reduce the 

amount of manual cleaning needed.
These panels work better above 200 °C. If you do most of your 

cooking below this temperature, occasionally remove the 

panels and wipe with a lint free cloth and hot soapy water. 

The panels should then be dried and replaced and the oven 

heated at 200 °C for about one hour. This will make sure that 

the panels are working effectively.

DO NOT use steel wool, oven cleaning pads, or any other 

materials that will scratch the surface.

Removing the Oven Linings

Some of the lining panels can be removed for cleaning. 
If you wish to clean the enamel interior of the oven, you 

will need to remove the shelves before removing the ‘Cook 

& Clean’ panels. You do not have to remove the support 

brackets to remove the panels. Lift each panel upward and 

slide forward off the support brackets 

(Fig.5-12)

.

Once the panels have been removed, the oven enamel 

interior can be cleaned.
Refit in the reverse order.

ArtNo.320-0002a Proplus oven door side screws

Fig.5-11

Fig.5-12