Falcon Hi-LITE 110, User'S Manual & Installation Instructions

20

Oven not coming on

Is the power on? Is the clock illuminated? If not, there 

may be something wrong with the power supply.
Is the cooker supply on at the isolator switch?
Has the time of day been set?
Is the key symbol [

F

] showing in the display to signify 

that the oven is locked? See the 

‘Clock’ 

section of the 

instructions for more information on the key lock 

feature.

The oven is not cooking evenly

Do not use a baking tray with dimensions larger than 

those specified in the section on 

‘General Oven Tips’.

If you are cooking a large item, be prepared to turn it 

round during cooking.
If two shelves are used, check that space has been left 

for the heat to circulate. When a baking tray is put into 

the oven, make sure that it is placed centrally on the 

shelf.
Check that the door seal is not damaged and that the 

door catch is adjusted so that the door is held firmly 

against the seal.
A dish of water when placed on the shelf should be the 

same depth all over. (For example, if it is deeper at the 

back, then the back of the cooker should be raised up or 

the front lowered.) If the cooker is not level arrange for 

your supplier to level it for you.

The timed oven is not coming on when automatic cooking

Has the oven knob been left in the OFF position by 

mistake?
Is the oven locked (see above)?

Oven temperature getting hotter as the cooker gets older

If turning the temperature down using the oven control 

knob has not worked, or has only worked for a short 

time, then you may need a new thermostat. This should 

be fitted by a service person.

An oven light is not working

The bulb has probably burnt out. You can buy a 

replacement bulb (which is not covered under the 
warranty) from a good electrical shop. Ask for a 15 W – 

230 V lamp, FOR OVENS. It must be a special bulb, heat 

resistant to 300 °C 

(Fig.6-1)

.

Before removing the existing bulb, turn off the power 

supply and make sure that the oven is cool. Open the 

oven door and remove the oven shelves.
Unscrew the bulb cover by turning counter-clockwise. It 

may be very stiff 

(Fig.6-2)

.

Taking care to protect your fingers with a glove in case 

the bulb should shatter, unscrew the old bulb.
Screw in the new bulb; screw back the bulb cover. Turn 

on the circuit breaker and check that the bulb now 

lights.

ArtNo.324-0005  Oven light bulb

Fig.6-1

ArtNo.320-0020 Oven back fixing screws

ArtNo.324-0007 Unscrewing the bulb cover

Fig.6-2