WARNING – SERVICING TO BE CARRIED OUT ONLY BY AN AUTHORISED PERSON
Disconnect from electricity before servicing. Check appliance is safe when you have finished.
31
ArtNo.090-0021 Hotplate removal
9. Servicing
n
n
BEFORE SERVICING ANY GAS CARRYING
COMPONENTS TURN OFF THE GAS SUPPLY
n
n
Check the appliance is gas sound after completion
of service. When checking for gas leaks DO NOT use
washing up liquid – this can corrode. Use a product
specifically manufactured for leak detection.
n
n
DO NOT use reconditioned or unauthorised gas
controls.
n
n
Disconnect from the electricity supply before
servicing, particularly before removing any of the
following: control panel, side panels, hotplate tray
or any electrical components or covers.
n
n
Before electrical reconnection, check that the
appliance is electrically safe.
1 Panels
1.1 To Remove the Control Panel
DISCONNECT FROM THE ELECTRICITY SUPPLY.
Pull off all the control knobs.
Open the grill and right-hand oven doors and remove
the 4 fixing screws underneath the control panel.
The control panel should drop down slightly. It is held at
the top by 2 holes in the top edge, one at each end, that
locate on tags on the inner panel (Fig.9-1). Clear the
control panel holes from the inner panel and pull the
control panel forward.
Disconnect the wiring from the rear.
Reassemble in reverse order. When replacing the leads
refer to the wiring diagram. Check the operation of the
timer.
1.2 To Remove the Side Panels
DISCONNECT FROM THE ELECTRICITY SUPPLY.
Remove the control panel (see 1.1). Pull the cooker
forward. Remove the 4 retaining screws for each panel
(1 at the front base, one on the top and 2 at the rear).
Reassemble in reverse order.
Fig.9-1
Fig.9-2
