Falcon Kitchener 90, User'S Manual & Installation Instructions

WARNING – SERVICING TO BE CARRIED OUT ONLY BY AN AUTHORISED PERSON

Disconnect from electricity before servicing. Check appliance is safe when you have finished.

34

Element fixing screws

ArtNo.321-0005 Fan oven element

retaining nuts and washers (3 off each) and lift the fan 

away from the rear of the cooker. 
Fit the new fan and reassemble in reverse order. Check 

the operation of the oven.

5.3  To Replace an Oven Element

DISCONNECT FROM THE ELECTRICITY SUPPLY.
Remove the oven inner back (see 5.1).
Remove the 2 screws from the top of the element and 

the 1 from the bottom of the element (Fig.9-4).  

Carefully lift the element out, disconnecting the 

terminals connected to the element (noting their 

positions). 
If it is not possible to disconnect the leads in this way, 

pull the cooker forward to gain access to the rear, 

remove the screws securing the electric cover to the 

back sheet, remove the cover and disconnect the 

terminals from the rear.
Fit the new element and reassemble in reverse order. 

Check the operation of the oven.

5.4  To Remove an Oven Element Thermal Cut-Out

DISCONNECT FROM THE ELECTRICITY SUPPLY.
Pull the cooker forward to gain access to the cover 

box. Undo the cover screws and lift clear. The cut-out 

is located on the earth plate beside the oven element 

connections. Disconnect the cut-out wiring. Undo the 

fixings that secure the cut-out to the earth plate and 

remove. 
Fit the replacement control and re-assemble in reverse 

order.

5.5  To Replace an Oven Thermostat

DISCONNECT FROM THE ELECTRICITY SUPPLY.
Remove the control panel and hotplate (see 1.1 & 2.1). 

Open the oven door and remove the oven furniture. 

Main Oven

Pull the cooker forward to gain access to the cover box 

at the rear of the cooker. Remove the 4 screws securing 

the cover and lift clear. The oven thermostat capillary is 

clamped to the oven back sheet with an earthing plate. 

Remove the screws and plate (Fig.9-5).

Tall Oven 

The oven thermostat capillary is clamped to the right-

hand rear upright with an earthing plate.
Remove the thermostat phial cover (2 screws). Unclip 

the thermostat phial from the clips in the oven back.
For either oven, feed the thermostat capillary out of 

the oven. Disconnect the wiring from the thermostat. 

Remove the 2 screws holding the thermostat to the 

mounting panel. Fit the new thermostat and reassemble 

in reverse order. Make sure that the phial is clipped 

to the oven back with the phial centrally positioned 

between the clips.
Remember to refit the earthing plate.
Check the operation of the thermostat.

Fig.9-5

A

B

A – Thermostat capillary,    B – Earthing plate

Fig.9-4