WARNING – SERVICING TO BE CARRIED OUT ONLY BY AN AUTHORISED PERSON
Disconnect from electricity before servicing. Check appliance is safe when you have finished.
37
4. Grill
4.1 To Replace the Grill Controller
n
DISCONNECT FROM ELECTRICITY SUPPLY.
Lift up the hob and remove the control panel (see
1.1
and
2.1
). Disconnect the wiring from the controller. Remove the
two screws holding the controller to the mounting panel. Fit
the new controller and reassemble in reverse order. Check for
correct operation.
4.2 To Remove a Grill Element
n
DISCONNECT FROM ELECTRICITY SUPPLY.
Remove the grill pan from the grill compartment. Undo the
two screws and washers in the grill roof and remove the
enamelled front shield.
Undo the 2 screws and washers securing the grill element
front support. Remove the screws from the grill elements.
Lift the elements out carefully and, noting their position,
disconnect the leads from the element terminals.
If it is not possible to disconnect the leads in this way, pull the
cooker forward to gain access to the rear. Undo the screws
securing the electric cover to the back sheet and remove
the cover. Disconnect the terminals from the rear. Fit new
elements and reassemble in the reverse order. Check the
operation of the grill.
5. Ovens
5.1 To Replace an Oven Thermostat
n
DISCONNECT FROM THE ELECTRICITY SUPPLY.
Lift the ceramic hob and remove the control panel (see
1.1
and
2.1
). Open the oven door. Remove the oven furniture.
For the right-hand oven, remove the thermostat phial cover
(two screws). Unclip the thermostat phial from the clips in the
oven back.
For the left-hand oven, pull cooker forward to gain access
to the cover box at the rear of the cooker. Remove the four
screws securing the cover and lift clear.
Feed the thermostat capillary out of the oven. Disconnect
the wiring from the thermostat. Remove two screws holding
thermostat to mounting panel. Fit new thermostat and
reassemble in reverse order. Make sure that the phial is
clipped to the oven back with the phial centrally positioned
between the clips.
Check the operation of the thermostat.
5.2 To Remove an Oven Element Thermal Cut-out
n
DISCONNECT FROM ELECTRICITY SUPPLY.
Pull the cooker forward to gain access to the cover box. Undo
the cover screws and lift clear. The cut-out is located on the
earth plate beside the oven element connections. Disconnect
the cut-out wiring. Undo the fixings that secure the cut-out to
the earth plate and remove. Fit the replacement control and
re-assemble in reverse order.
Summary of Contents for Nexus 90 Induction
