-
2. SYSTEM OPERATION
2.1. System Status Memory
The system will enter the same mode after powering on as when it was powered off.
2.2. Button Function
Button
Armed
Disarmed
IGN On
BTN #1 once
Arm
Arm
Door Lock
BTN #2 once
Disarm
Disarm
Door Unlock
BTN #1 2 sec.
Panic
Panic
BTN #3 once
Car Finder
Car Finder
BTN #3 2 sec.
Boot Release
Boot Release
Boot Release
BTN #4 3 sec.
Remote Engine Start
Remote Engine Start
Anti-hijacking
BTN #2+3 once*
Status Report
Status Report
Status Report
BTN #1+2 once
Silent Disarm Silent
Disarm
Silent Disarm
BTN #1+3**
CH3
CH3
CH3
BTN #1 then #1 once
Arm & Bypass I
BTN #1 then #1 twice
Arm & Bypass II
BTN #1+4 1 sec.
Passive Arming On/Off
Passive Arming On/Off
BTN #2+4 once*
2way RC Power Saving
2way RC Power Saving
BTN #3+4 once*
2way RC Vibration On/Off 2way RC Vibration On/Off
2way RC Vibration On/Off
*=For 2way LCD or LED remotes only.
**=The CH3 output will be continuous whilst BTN #1+3 are pressed.
2.3. Programming New Remote Controls
The included remote controls have been programmed to the system in the factory. Follow the
procedure below to program a new remote control to the system:
- Turn the ignition on with the system disarmed.
- Within 10 seconds, press valet switch 3 times. (or 6 times if pager upgrade is installed).
- The siren sounds for 2 sec. to confirm the system is now in code learning mode.
- Within 10 sec., press any button of 1
st
remote control
The siren will sound for 1 sec. and hazard lights flash twice to confirm the 1
st
remote has
been programmed to the system and all the previous codes in the system will be erased
entirely.
- Within 10 sec., repeat for the 2
nd
remote control and again for 3
rd
and 4
th
remotes as
applicable.
* Up to 4 remotes can be programmed to the system
* The system will leave the code learning mode after programming 4 remotes to the system
and the siren will sound for 2 seconds
to confirm.
* If no buttons are pressed within 10 seconds, the system will leave the learning code mode
and the siren will sound for 2 seconds to confirm.
* The system will leave the code learning mode if the ignition is turned off at any time and the
siren will sound for 2 seconds to confirm.
2.4. To Arm the System
A. By remote control
Remote Arming:
- With the system disarmed and ignition off.
- Press button #1 once.
- Siren
chirps
once.
- Hazard lights flash once.
- Doors lock and windows close.*
- LED flashes slowly to confirm the system is armed.
* Window closure requires car with total closure or separate window closure module.
B. By passive arming
To turn the Passive Arming feature on or off:
- While the system is disarmed or the ignition is on:
- Press button #1+4 for 1 sec.
- The siren will chirp once to confirm the function is on.
- The siren will chirp twice to confirm the function is off.
When Passive Arming is on:
- Turn the ignition off and close the doors, bonnet and boot properly.
- LED indicator flashes rapidly.
- The system will automatically be armed 30sec. later.
- The siren chirps once and hazard lights flash once to confirm the system is armed.
