-
* The doors will also lock when the system is armed if optional feature #2 is enabled.
* The 30 second countdown will be interrupted if any of the doors, boot or bonnet are opened.
Closing the last opened door, boot or bonnet will restart the 30 sec. countdown.
C. By auto rearming
If optional feature #11 is enabled the system will rearm itself to avoid accidental disarming as
follows:
- Disarm alarm by remote control.
- The system will arm itself again 30 sec. later unless any of the doors, boot or bonnet are
opened.
2.5. Open Circuit Alert
If a door/boot/bonnet is open when the alarm is armed by the remote control the siren will chirp
once and hazard lights flash once as normal and then the siren will chirp and the hazard lights
flash as follows:
When programmable feature #10 is disabled.
- The siren chirps 3 times and the hazard lights flash 3 times if any of the doors, boot or
bonnet are not closed properly. The door/boot/bonnet input will be bypassed until it is closed
properly.
When programmable feature #10 is set as 25/40/60 sec.
- The siren chirps 3 times and hazard lights flash 3 times when remote arming the system if
the boot or bonnet is not closed properly. The boot/bonnet input will be bypassed until it is
closed properly.
- The siren chirps 3 times and hazard lights flash 3 times 25/40/60 seconds (depending on
setting of feature #10) after remote arming the system if a door is not closed properly. The
door input will be bypassed until it is closed properly.
2.6. To Disarm the System
A. By remote control
- With the system armed.
- Press button #2 once.
- Siren chirps twice.
- Hazard lights flash twice.
- Doors
unlock.*
- Immobiliser turns off.
- LED turns off.
- Interior light turns on for 20 sec. (if connected).
*
The system will unlock the drivers door only if the optional feature #7 is programmed as
“Driver” Pressing button #2 again will unlock the passenger doors. Note: Requires special
wiring of central locking.
B. By emergency override
If the remote controls are lost or broken the system can still be disarmed as follows:
- With the system armed or alarming.
- Turn the ignition on.*
- The LED starts to flash 10 times slowly after 2 sec.
- Press the valet switch once after the LED flashes a number of times equal to the override
code.*
- The system will be overridden and enter disarm mode.
* If the previous operation failed turn the ignition off and start again from the beginning.
After 3 failed attempts you must wait for 3 minutes before the emergency override will
work again.
2.7. LED Indications
A. System status
Slow Flash = Armed
Fast flash
= Auto rearm or passive arming
Steady Light = Valet mode
No Light
= Disarmed
