-
2.10. Stop the system when alarming
A. Press button #1 once
When the system is triggered, the siren and hazard lights are activated, press button #1 once,
the siren and hazard lights will be deactivated but the system will remain in armed mode.
B. Press button #2 once
When the system is triggered, the siren and hazard lights are activated, pressing button #2
once will disarm the system and the siren will chirp 4 times, the hazard lights will flash twice
to confirm and the LED will flash to indicate the triggered zone.
2.11. Panic Mode
A. With the system armed
- Press button #1 for 2 seconds, the siren will sound and hazard lights flash for one cycle. The
system will remain armed.
B. With the system disarmed
- Press button #1 for 2 seconds and the system will arm and then the siren will sound and the
hazard lights will flash for one cycle. The system will remain armed.
* During the panic mode, pressing button #1 once will deactivate the siren and hazard lights
and the system will remain in the arm mode.
* During the panic mode, pressing button #2 once will deactivate the siren and hazard lights
and the system will be disarmed.
2.12. Temporary Sensor Bypass
The plug in sensors can be bypassed temporarily until the next arming of the system as follows:
- Press Button #1 to arm the system.
- Within 2 sec. press button #1 again.
- The hazard lights flash once to confirm the warning stage of the plug in sensors has been
bypassed.
- And then press button #1 again within 2 sec.
- The hazard lights flash once again to confirm the plug in sensors have been bypassed
completely.
2.13. Ignition Lock and Unlock
A. Ignition lock
After turning the ignition on, the system will lock the doors automatically depending on the
setting of programmable feature #3.
B. Ignition unlock
After turning the ignition off, the system will unlock the doors automatically depending on the
setting of programmable feature #4.
C. Whilst driving
If the doors are unlocked during driving they will be locked again automatically after stepping
on the brake pedal. (Brake light wire must be connected).
2.14. Door Open Alerts
The hazard lights will flash when a door is opened with ignition on. The operation will depend
on the setting of programmable feature #13.
2.15. Boot Release
A. With the system armed
Pressing button #3 for 2 sec. will operate the boot release output. If programmable feature
#15 is set as disabled the plug in sensors will be bypassed until the boot is closed.
If programmable feature #15 is set as enabled the system will be disarmed.
B. With the system disarmed
Pressing button #3 for 2 sec. will operate the boot release output.
C. During Auto-rearming
Pressing button #3 for 2 sec. will operate the boot release output and cancel the auto-rearming
procedure.
