Falcon Professional Deluxe 100, User'S Manual & Installation Instructions

16

ArtNo.320-0002a Proplus oven door side screws

ArtNo.320-0022 Tall oven side support

Glass Fronted Door Panels

The oven door front panels can be taken off so that the glass 
panels can be cleaned. Move the cooker forward to gain 
access to the sides (see the 

‘Moving the Cooker’

 section under 

‘Installation’

).

Open the oven door slightly and remove the front panel 
fixing screws from the door sides, two each side 

(Fig.5-10)

.

Carefully lift off the outer door panel. The inside face of the 
glass panels can now be cleaned – take care not to disturb or 
wet the door insulation.

Note: 

If the door is triple glazed then the inner two panels are 

fixed together and should not be separated. After cleaning, 
carefully refit the outer door panel and replace the side fixing 
screws.

n

n

DO NOT use harsh abrasive cleaners or sharp metal 
scrapers to clean the

oven door glass since they can 

scratch the surface, which may result in shattering of 
the glass.

Ovens

‘Cook & Clean’ Panels

The main oven has panels which have been coated with a 
special enamel that partly cleans itself. This does not stop 
all marks on the lining, but helps to reduce the amount of 
manual cleaning needed.

The ‘Cook & Clean’ panels work better above 200 °C. If you do 
most of your cooking below this temperature, occasionally 
remove the panels and wipe with a lint free cloth and hot 
soapy water. The panels should then be dried and replaced 
and the oven heated at 200 °C for about one hour. This 
will make sure that the ‘Cook & Clean’ panels are working 
effectively.

DO NOT use steel wool, oven cleaning pads, or any other 
materials that will scratch the surface.

Removing the Main Oven Linings

Some of the lining panels can be removed for cleaning. 

If you wish to clean the enamel interior of the oven, you 
will need to remove the shelves before removing the ‘Cook 
& Clean’ panels . You do not have to remove the support 
brackets to remove the panels. Lift each panel upward and 
slide forward off the support brackets 

(Fig.5-11)

.

Once the panels have been removed, the oven enamel 
interior can be cleaned.

Refit in the reverse order.

The Tall Oven

To clean the oven sides, slide out the shelves, unhook the 
supports from the oven sides, and lift out 

(Fig.5-12)

.

Fig.5-12

Fig.5-11

Fig.5-10