29
6.6 How to Display Programmed Settings
1. The UPS must be turned on and operating in on-line inverter mode prior to attempting to read the
“programmed settings”.
2. Depress the “Function” button and the following first function parameter will be displayed:
The first function status
displayed will be the audible
alarm buzzer status. It is
shown here to be turned on.
If the “Previous Page/Change
Setting” button is pressed, the
audible alarm will be turned
off. Depressing the button
again will turn the alarm back
on.
Depress the “Next Page”
button.
Next, the self-test status is
displayed. Here the self-test is
shown to be in the “Test Not
On” state.
If the “Previous Page/Change
Setting” button is pressed, a
UPS self-test will be initiated
and the following displays will
be shown.
Depress the “Next Page”
button.
Go to the next page.
