32.
Reinstall the two rear panel screws removed in step 2 and tighten.
33.
Gently place the UPS on its side with the bottom facing you.
34.
Reinstall the four screws removed in step 4 and tighten.
35.
If the UPS is model SG1K-1T reinstall the battery fuse and cap.
36.
Connect the UPS to an utility power source.
37.
Turn on the UPS power switch located on the rear panel. The UPS should power up
and function normally as defined in the Owner’s Manual.
38.
Leave the UPS turned on for 24 hours to allow the batteries to fully charge.
.
9
