This device
MUST NOT be fitted on PROPANE
(I
3
p)
models.
1.10 BURNER ADJUSTMENTS
1.10.1 To Adjust
a) Fit a suitable pressure gauge to test point and light grill. Consult Users Instructions for
lighting procedure.
b) With one burner (pair) at FULL FLAME position, adjust pressure if necessary. Values are
stated in Section 1.9.
c) Check that all burner ports cross light satisfactorily.
d) Turn control to LOW FLAME position and check that flame intensity reduces.
1.10.2 Low Flame Setting
The gas control is provided with a LOW FLAME setting. Check it functions satisfactorily. In
event of adjustment being necessary, follow procedure detailed in Section 3.6.2.
1.11 FLAME FAILURE THERMOCOUPLE POSITION
The thermocouple sensing tip should be mounted 2.5mm below the burner plaques for
robust operation. The tip should protrude 9mm across the ceramic plaque.
Note: The tip must not touch any nearby surface.
SECTION 2 - ASSEMBLY and COMMISSIONING
2.1 UNPACKING
2.1.1 Grill Unit
Unpack grill unit and check that all components are undamaged. Parts supplied loose (1 off
each) are as specified in the contents list below. -
Brander Drip Trough, Brander, Wire Grid,
Drip Tray, Gas Governor (Natural Gas Only)
Flue Diverter
Appliance Mounting Accessories
The mounting method will have been decided at time of ordering. The option chosen will be
supplied in a separate pack or carton.
GRILL MOUNTING CHECK LISTS
Important Note
When mounting grill on bench legs, the placement surface should be constructed of a
non-combustible material.
2.1.2 Bench Leg Assembly Instructions
Bench legs are fitted to grill underside using
fixings provided. It is recommended that these be fitted when commencing assembly. This
operation is best facilitated by placing unit on its back.
The kit comprises the following parts
–
Description
No. Off
Bench Leg
4
Leg Bolt (M8 x 30_
4
Grill Fixing Screw (M6 x 20)
12
Washer (M6)
12
Serrated Washer (M6)
12
Each leg is fixed by three M6 screws to the grill underside. It may then be positioned and
secured to bench or worktop with an M8 bolt fed from beneath desired surface into threaded
leg boss. Fixing centres are as fig 1
Summary of Contents for STEAKHOUSE PLUS G1528
Page 6: ...Figure 1 ...
