FALMEC EUROP90E1, Instruction Booklet

13

ENGLISH

  INSTALLATION

  only intended for qualified personnel

Before installing the shelf,

carefully read the chapter

'SAFETY INSTRUCTIONS AND WARNINGS'.

TECHNICAL FEATURES

The technical specifications are exhibited on the labels located inside 

the shelf.

ELECTRICAL CONNECTION

(only intended for qualified personnel)

Disconnect the equipment from electrical mains power 

supply before carrying out any operations on the shelf.

Ensure that the wires inside the shelf are not disconnected 

or cut:

in the event of damage, contact your nearest Servicing Depart-

ment.

Refer to qualified personnel for electrical connections.

Connection must be carried out in compliance with the provisions 

of law in force.

Before connecting the shelf to the electrical mains power supply, check 
that:
•  voltage supply corresponds with what is reported on the data plate 

located inside the shelf;

•  the electrical system is compliant and can withstand the load (see 

the technical specifications located inside the shelf );

•  the power supply plug and cable do not come into contact with 

temperatures exceeding 70 °C;

•  the power supply system is effectively and properly connected to 

earth in compliance with regulations in force;

•  the socket used to connect the shelf is within reach.

In case of:
•  devices fitted with cables without a plug: the type of plug to use is 

a ''standardised'' one. The wires must be connected as follows: yel-
low-green for earthing, blue for neutral and brown for the phase. The 
plug must be connected to an adequate safety socket.

•  fixed equipment not provided with a power supply cable and plug, 

or any other device that ensures disconnection from the electrical 
mains, with an opening gap of the contacts that enables total discon-
nection in overvoltage category III conditions.

  Said disconnection devices must be provided in the mains power 

supply in compliance with installation regulations.

The yellow/green earth cable must not be cut off by the switch.
The Manufacturer declines all responsibility for failure to comply with 
the safety regulations.

 MAINTENANCE

Before cleaning or carrying out maintenance operations, 

disconnect the equipment by removing the plug or 

switching off the main switch.

Do not use detergents containing abrasive, acidic or corrosive 

substances or abrasive cloths.

Regular maintenance guarantees proper operation and performance 
over time.
Special attention is to be paid to the 

metal anti-grease filters 

: fre-

quent cleaning of the filters and their supports ensures that no flamma-
ble grease is accumulated.

CLEANING OF EXTERNAL SURFACES

You are advised to clean the external surfaces of the shelf 

at least once 

every 15 days

to prevent oily substances and grease from sticking to 

them. To clean the brushed stainless steel shelf, the Manufacturer rec-
ommends using "Magic Steel" wipes.
Alternatively 

and for all the other types of surfaces

, it can be cleaned 

using a damp cloth, slightly moistened with mild, liquid detergent or 
denatured alcohol.
Complete cleaning by rinsing well and drying with soft cloths. 

Do not use too much moisture or water around the push 

button control panel and lighting devices in order to pre-

vent humidity from reaching electronic parts.

The glass panels can only be cleaned with specific, non-corrosive or 
non-abrasive detergents using a soft cloth.
The Manufacturer declines all responsibility for failure to comply with 
these instructions.

LIGHTING

The range shelf is equipped with high efficiency, low consumption LED 
spotlights with an extremely long life-span under normal use condi-
tions.
Should the LED spotlight need to be replaced, proceed as shown in 
the figure.

12V

3

1

2