25
2. MECHANICAL PUSH BUTTON PANEL CONTROL (ARTEMIDE, MERCURIO,
SATURNO, VULCANO, PULSAR, MILLENIUM)
Light key: Light ON/OFF
Motor speed keys 1, 2, 3
OFF key switches off the motor
FILTERS
H
1. METAL FILTERS
Pull on the specific handle to remove the metal filters. With Millenium hoods open the
exhaust panel on the edge to access the metal filter.
2. CARBON FILTERS
To replace the activated carbon filters, proceed as follows: remove the metal filter as indi-
cated above. Now the motor compartment can be accessed and it is possible to proceed
with assembling/disassembling the carbon filters as illustrated in the figure below.
To order new carbon fi lters contact your distributor/dealer.
VALID ONLY FOR ITALY:
Download the fi lter order form from the website: www.falmec.com.
LIGHTING
ASSEMBLY AND REPLACEMENT
I
SPOTLIGHT
To replace the lamp for “Round halogen light”:
a) Make sure the appliance is disconnected from the mains power supply.
b) Remove, by levering with a screwdriver, the support ring A for the cover glass.
c) Remove the cover glass B to access the light compartment.
d) Replace the lamp with the same type (halogen, max 20 W, 12 Volt, G4 fitting).
e) Replace the glass cover B and fasten it using the special ring A.
English
Summary of Contents for VULCANO
