4.4.3 Remote Programming mobile
The ECII™ Flex can be programmed by using an app provided by FältCom free of charge for
Android or iPhone.
For Android, go to Google Play shop and search for “Flex Android”, download and install.
For iPhone, start the browser and enter the address:
www.faltcom.se/flexconfig/index.html
Follow the steps in the app and view the help section for more information.
The app is write only, this means that the user can write and change the settings but not read
and view the current settings in the ECII™ Flex. This is due to restrictions in Android and iOS
not allowing DTMF reception in the application.
4.4.4 Alarm log
The ECII™ Flex will save the ten most recent emergency alarm calls in an alarm log. To re-
trieve and read the log use the Flex Programmer SW. The Flex Programmer will translate the
data from the ECII™ Flex to time and date of the alarm. This means that if the ECII™ Flex is
powered off the alarm time in the log will be incorrect.
5
Installation instructions
Only suitably qualified personnel may install the ECII™ Flex. Expertise, technical skill and cor-
rect equipment are required to ensure safe and efficient installation.
Mind your own safety when installing ECII™ Flex. You must never work in an open
lift shaft without a safety harness. Be extremely careful and break current if you work
close to a voltage of 230-400V, e.g. in the lift motor room. Never disconnect a cable
before you have made sure that it is not live.
Start by selecting a suitable place for the ECII™ Flex. Usually you can find an easily accessible
and yet well protected place behind the lift panel. Avoid installing ECII™ Flex in a corner or
behind anything that may reflect the sound. Such installation might lead to acoustic feedback
instability between the loudspeaker and the microphone. You must be able to access the exist-
ing suspension cable and the alarm button in the lift. Also keep in mind that you must be able
to access the back of the lift phone in order to connect cables and program functions. Normally
this is easier to do on the inside of the lift, before the lift phone is screw-mounted.
Make sure that you will avoid sawing or drilling through existing cabling when you make
any holes!
Frame mounting
1.
Mark and pre-drill the holes for the lift phone frame according to the enclosed drill tem-
plate. Drill the holes for the cables to the alarm button and telephone connection ac-
cording to the drill template.
162187 Manual FältCom ECII™ Flex
Page 9 of 40
