13
LIQUID-FOOT PRO SERIES MIDI FOOT CONTROLLER
MIDI IN>:
When this switch is moved to the left, MIDI IN (VIA MIDI OUT PORT) is turned off. When
the switch is moved to the right, then MIDI-IN signal can be received from the MIDI-OUT
connector. Some devices (such as the AXE-FX and Liquid-Tracks) can send MIDI-IN and
MIDI-OUT signals on one cable. Connect one cable from the Liquid-Tracks or AXE-FX
from the MIDI-IN port on the device to the MIDI-OUT port on the Liquid-Foot controller.
Insure the switch is to the right. If you connect MIDI-IN cable to the MIDI-IN port on the
Liquid-Foot Controller, move the switch to the left to shut off the signal from the MIDI-
OUT.
EXP1-2:
Single and Dual POT expression pedals can be connected to these ports. You
MUST
calibrate each pedal in the port it is to be used. If you move the pedal to a different
Expression pedal port- you will need to recalibrate. Expression pedal ports can modify
any MIDI message (PC , CC, NOTE ON, NOTE OFF, etc…)
Certain types of switch pedals may be compatible with this device. The switch pedal
must support (NO) Normally Open switch capability, and the connector must only switch
the Tip and Sleeve. The RING must not be connected when using a switch pedal.
Damage may occur if this is not adhered to. For ¼ “ TS (MONO PLUG) switch pedals, a
mixer type Y cable must be used, with the TIP cable connected to the switch pedal.
Custom connectors can be placed on the switch pedal. Simply connect the sleeve and tip
to the wires of the switch pedal. Leave the RING unconnected. You must ONLY insert a
TRS connector into the controller or damage may occur.
MIDI OUT:
This connector supports simultaneous MIDI-IN, MIDI-OUT and POWER signals depending
on the equipment it is connected too. When plugged into the Liquid-Tracks, or an AXE-
FX as an example, one 7 pin cable will handle all three signals. It will act in the same
manner as the Ethernet “TO RIG” port, minus a few functional “Extra” capabilities
specific to the Ethernet HUB rack device.
MIDI IN:
Will receive MIDI-IN signal. If using MIDI-IN via the “TO RIG” Ethernet adaptor, or via the
MIDI-OUT cable, do not put a signal or cable into this connector. If you plan to use this
connector, please insure the MIDI IN> switch defined above is moved to the left.
