70
LIQUID-FOOT PRO SERIES MIDI FOOT CONTROLLER
Momentary
-- when you first press the switch Pedal, it will send a data value of 127 to
the controller you’ve assigned. When you let go of the pedal, it will send a 0 data
message.
One-Shot
--
This mode will send a data value of 127 to the configured MIDI
command every time you press the switch pedal.
Broadcast
--
This mode will behave as One-Shot mode, however, it will send a data
value of 127 to the configured MIDI command for each MIDI channel (from 1-16). As an
example, this can be used to trigger a TAP-TEMPO CC message to all MIDI devices on all
MIDI channels at the same time.
Trigger IA Switch
--
This mode will act lie a one-shot pedal type, however, instead of
sending a CC value, it will trigger all the commands as programmed into the switch you
point to in the midi programming for this expression pedal in 2: Data parameter. Values
from 1-64 are valid. For example, if expression pedal one is set as an IA Trig Switch, and
you program the midi command for Expression pedal #1 to a value of (midi channel: 1,
Midi Command: B:, Data1:
EXPRESSION PEDAL CALIBRATE
Each time you place a new expression pedal into an expression pedal port that has not been
calibrated, or was previously calibrated to a different pedal, you must re-calibrate for proper
operation. This process can take 2-3 seconds per expression pedal port.
Plug each of your expression pedals into all the appropriate ports. Currently the Liquid-Foot
processes linear one and two pot expression pedals that are passive. DO NOT plug active
expression pedals (those that have a power source of any kind) into the Liquid-Foot. Damage
may occur.
Expression Pedal # being calibrated
