71
LIQUID-FOOT PRO SERIES MIDI FOOT CONTROLLER
STEPS:
1.
Press the expression pedal three times all the way to the TIP, and back down to the
heel. Rock back and forth and utilize the entire swing of the foot pedal for proper
calibration. You will notice a blinking RED light that scrolls up and down the S1-S13
switches. If the blinking light does not move while you are rocking the pedal, please
check your wiring connections. Insure that the Expression pedal you are calibrating
(see the number on the top left of the LCD), is the same pedal you are moving.
2.
To SAVE your calibration you MUST press S16 (SELECT). If you press S15 (NEXT), you
will skip to begin calibrating the next Expression pedal (1-4), but it WILL NOT save
your calibration. This may create the perception of strange behavior when you use
your expression pedals. Essentially, you are using an un-calibrated expression pedal
if you have not pressed S16 (SELECT).
3.
Continue this process for each of the expression pedals you have installed,
repositioned, or otherwise modified from the previous calibration settings.
DISPLAY VALUES
Press the UP/DOWN button to scroll between DEC and HEX display. The default is Decimal.
During MIDI MESSAGE programming screens, Data values can be shown in HEX (00-F7) or DEC
(0-127). In most cases you will not modify this setting. Press S16 (SELECT) to save your
modifications to this setting.
PRESET OFFSET
Press the UP/DOWN button to scroll between 0 and 1. All presets, songs, set-lists, etc. begin at
0 within the Liquid-Foot. Some external hardware defaults to 0 as well. Other hardware presets
start at 1. Given some hardware is not configurable, we have given you the option of selecting
how you would like to handle the numbering system. You can switch between the two as often
as you like. No other system or re-programming modifications are needed within the Liquid-Foot
when you toggle between the two options. Press S16 (SELECT) to save your changes.
