Powering
The device has dual removable (hot-swap compatible) power supply units AC
⏦
110-240V (2.5 A) with standard
IEC compatible sockets with Maximum power consumption of 125 W.
Configuration
Once logged in, we recommend clicking the “Check for updates” button in the QuickSet menu, as updating your
RouterOS software to the latest version ensures the best performance and stability. For wireless models, please
make sure you have selected the country where the device will be used, to conform with local regulations.
RouterOS includes many configuration options in addition to what is described in this document. We suggest
starting here to get yourself accustomed to the possibilities:
. In case IP connection is not available,
the Winbox tool (
) can be used to connect to the MAC address of the device from the LAN side
(all access is blocked from the Internet port by default).
For recovery purposes, it is possible to boot the device for reinstallation, see a section Reset button.
Extension Slots and Ports
•
2x M.2 slots, which accept 800mm Key-M x4 PCIe 2.0 modules. M.2 slots are located on PCB board inside
the device. In order to access them remove screws on the back of the router for upper cover and while
lifting up and pulling towards cover slides off.
•
microSD card slot.
•
Smart Card slot for private key storage.
•
1 Gigabit Ethernet port.
•
8 SFP+ ports for 10 Gigabit connectivity.
•
USB slot type A.
•
microUSB slot type AB.
•
Automatic fan speed control.
Reset button
The reset button has two functions:
•
Hold this button during boot time until LED light starts flashing, release the button to reset RouterOS
configuration.
•
Or Keep holding the button for 5 more seconds until LED turns off, then release it to make the
RouterBOARD look for Netinstall servers.
Regardless of the above option used, the system will load the backup RouterBOOT loader if the button is pressed
before power is applied to the device. Useful for RouterBOOT debugging and recovery.
Accessories
Package includes the following accessories that come with the device:
•
EU/US AC
⏦
power cord, D03+QT3 H05VV-F 3x0.75 mm 2 1.83 m RoHS.
•
Fastening set for rackmount case K-10 R2.
•
Rackmount Case x72 Side Bracket.
Please visit wiki pages for MikroTik SFP module compatibility table:
https://wiki.mikrotik.com/wiki/MikroTik_SFP_module_compatibility_table
See mikrotik.com/products for the latest version of this document.
Document #50312 Modified on: 09.OKT.2019
