Shenzhen Hpmont Technology Co., Ltd.
Chapter 6 Function Introduction
HD3N-L Series User Manual V1.0
- 27
-
6.2
Group F: General Parameters
6.2.1
F00: Basic Parameters
Ref. Code
Function Description
Setting Range [Default]
F00.00
Motor type
[0]
0: Asynchronous motor (Asy. motor).
F00.01
Control mode
0 - 6 [1]
0: V/f control. Constant control voltage/frequency rat.
•
Suitable for special elevator applications. This mode does not need the encoder, and the control effect
is not as good as vector control.
•
When select V/f control, please set gropu F07 (V/f control parameters), to achieve good control effect.
1: SVC1 control, open-loop vector control.
2 - 4: Unused.
5: SVC5 control, optimized flux vector control.
6: SVC6 control, current vector control.
Note:
1. V/f and SVC control is suitable for a temporary run mode where the encoder is not installed on themotor and
the elevator needs to inspection run.
2. When selecting SVC, you need to first perform autotuning of the motor parameters, please refer to F07.06. At
the same time, set the vector control parameters (group F08) to exert excellent vector control effect.
F00.02
Elevator rated speed
0.100 - 4.000 [1.500m/s]
F00.03
Controller Max. output frequency
5.00
-
100.00
[
50.00Hz
]
Defines the Max. frequency that the controller is allowed to output.
•
Be careful to set reasonable parameters according to the nameplate of the motor and the actual
operating conditions.
F00.04
Motor mechanical parameter
10.0 - 6000.0 [60.0]
F00.05
Operating mode
0 - 5 [0]
0: Keypad control.
•
Controlled by pressing the
(standard) /
RUN
(optional) or
(standard) /
STOP
(optional), set the
run speed in F00.07.
1: Terminal analogue control.
•
The running command is controlled by the terminal (UP and DN)
•
The run speed is set by analogue input terminals.
2: Terminal multi-speed (MS) control.
•
The running command is controlled by the terminal (UP and DN).
•
the run speed is set by the combination of terminals (MS1, MS2, MS3).
3 - 5: Unused.
F00.07
Speed setting of keypad
0.000 - F00.02 [1.500m/s]
F00.05 = 0, set the objective speed at running.
F00.08
Run direction
0,1 [0]
0: The same as run command.
1: Opposite to run command.
6
