background image

 

ENGLISH 

 

Important safety instructions! Please read before connection!

 

 
 

DANGER! (Electrical shock due to high voltages in the device) 

The housing must not be removed! There are 

no

 parts to be maintained in the device. 

Inside the unit there are components which are under high electrical voltage. 

 
Before each use, check the device for damage or the absence of components, protective 

devices or housing parts. If this is the case, the device must not be used!  
 

Leave maintenance and repair work to a qualified service workshop or contact your 
dealer. In the case of a malfunction of the device, operation must also be stopped 

immediately until the device has been repaired by a specialist! 
 

 

DANGER! (Electric shock due to short circuit) 

Modifications to the power cord or plug are prohibited. If the power cord is damaged, it 

must be replaced immediately with an original spare part from the manufacturer.  
 

Always make sure that the grounding of the device is maintained. Only use the supplied 
power cables and always maintain the earthed protective contacts on the side. Make sure 

that the sockets used have a properly functioning protective earth. 
 

Failure to do so may result in fire or death due to electric shock! 
 

 

DANGER! (For babies and children) 

Dispose of or store any packaging material properly! Packaging material must be kept out 
of the reach of babies and children due to the 

risk of suffocation

 

Ensure that children never use the appliance unattended! In addition, make sure that 
children do not remove (small) parts from the device, as they could suffocate by swallowing 

parts! 
 

 

Hint! (Fire hazard due to overheating) 

The maximum permissible ambient temperature of this device is 

40°C

.   

 

 

Ensure that the unit is placed in a well-ventilated location away from direct heat sources, 
naked flames, combustible materials, and liquids. A minimum distance of 1 m is required. 

 
Do not tape or cover the ventilation slots of the unit, or insert objects into the unit.

 

 
 

 
 

 

 
 

 
 

Summary of Contents for CM1










Reviews: