82
Parameter
Range
Description
Head Sensi
0 ~15
Adjust the pad sensitivity. A high value will produce loud sound,
even you strike softly. A low value will produce low sound, even
you strike heavily.
Rim Sensi
0 ~15
Adjust the sensitivity of rim shot.
Threshold
0 ~15
Trigger signal will produce sound only when it is above the
threshold level. Although this setting can prevent unwanted
sounding, such as crosstalk from other pads, if set to a higher
level, no sound will be produced when you strike lightly.
For example, B will produce sound but A and C will not.
To get a proper threshold value:
1. Set the value to a low level.
2. Raise the value gradually
while striking the pad.
3. Repeat step2 until you get
an appropriate level.
Head/Rim Adj
0 ~15
Adjust the disturbance between head and rim shot. (Only for
Snare and Tom)
X-STICK Level
0~4
When the value is set to “0”, it plays only the rim shot sound,
but no cross stick sound. As the value increases, the cross stick
sound will be more noticeable.
Note: This parameter is not available until X-Stick function is
turned on in KIT menu.
X-Talk
0 ~15
Crosstalk means when hitting a pad, another pad is mistakenly
triggered, which should have be avoided. This may happen
when two pads sit on the same stand.
For example: when you hit the Snare, if both Snare and Tom1
produce sound, you can raise Tom1‘s “XTALK” value to prevent
crosstalk.
Note: Make sure the “XTALK” value is set to a proper level. If
the value is set too high, when you hit two pads at the same
time, the pad being struck gently may be judged as “crosstalk”
and will not produce sound.
Curve
Normal, EXP-1,
EXP-2, LOG-1,
LOG-2, Loud
This setting adjusts the relationship between the striking force
and the response volume.
Please refer to Curve description in this chapter.
Retrig-C
0 ~15
This setting is to cancel “re-triggering”. Re-triggering means
when you strike a pad, you hear two sounds from this strike
because of pad vibration.
Note: If the value is set too high, sounds may be omitted when
you play fast; if the value is set too low, re-triggering may not
be prevented. Better set the value to the minimum level requi-
red but still can prevent re-triggering.
Close Point
0 ~ 2
Adjust the close point settings:
Pedal Sensi
0 ~15
Adjust the sensitivity of Hi-Hat control pedal.
Bow-Sensi
0 ~15
Adjust the sensitivity of cymbal bow.
Edge-Sensi
0 ~15
Adjust the sensitivity of cymbal edge.
Bell-Sensi
0 ~15
Adjust the sensitivity of cymbal bell.
Trigger parameters and their range:
DEUTSCH
ENGLISH
Summary of Contents for DRU0038567-000
